RM RM Eye Instrukcja Obsługi Pobierz pdf (Strona 14)

RM-eye instruction manual Ver.1.0

Appendix 1. Firmware update

In order to update a firmware of RM-eye, you can connect between CN2 and PC using a serial

straight cable.

After confirmation that a power is shut down, you can slide pin1 and pin2 of SW5 to “ON”, and

turn on a power.

Please download a latest firmware from RM-eye support page, and update a firmware using

writing software. After writing a firmware, you can turn off a power and slide pin1 and pin2 of SW5

to “OFF”.

Please notice that parameters which you set is deleted if you update a firmware.

Figure 7. Firmware update

Pin Function RM-eye

1 NC -

Connect to pin4 with 220 ohm

3 TX 2

4 Connect to pin2 with 220 ohm -

5 GND 3

6 NC -

7 Connect to pin8 -

8 Connect to pin7 -

9 NC -

You can use a serial straight cable which is a standard equipment of KHR-1, KHR-2HV,

KHR-1HV and Manoi.

CN2

3 2 1

1 2 3 4 5

6 7 8 9

1 2 ... 9 10 11 12 13 14 15

Brak uwag

RM RM Eye Instrukcja Obsługi Strona 14